The Plant Protection Products Regulations 2005

1.  The packaging containing the plant protection product shall be marked clearly and indelibly with the following information—

(a) the trade name or designation of the plant protection product;

(b) the name and address of the holder of the approval and the approval number of the plant protection product and, if different, the name and address of the person responsible for the final packaging and labelling or for the final labelling of the plant protection product on the market;

(c) the name and the amount of each active substance; the name must be—

(i) the same as that listed in Annex I to Council Directive 67/548/EEC as amended, if any;

(ii) the common name given by the International Organisation for Standardization, if any; or

(iii) its chemical designation according to the rules of the International Union of Pure and Applied Chemistry contained in the Nomenclature of Organic Chemistry, 1979 edition(1) as read with A Guide to IUPAC Nomenclature of Organic Compounds (recommendations 1993)(2);

(d) the net quantity of plant protection product given in legal units of measurement;

(e) the formulation batch number or some means of identifying it;

(f) the particulars required for the product in Articles 10 to 12 of Council Directive 1999/45/EC as amended;

(g) the nature of any special risks for humans, animals or the environment, by means of standard phrases selected as appropriate from those given in Annex IV;

(h) safety precautions for the protection of humans, animals or the environment, in the form of standard phrases selected as appropriate from those given in Annex V;

(i) the type of action of the plant protection product;

(j) the type of preparation;

(k) the uses for which the plant protection product has been approved and any specific agricultural, plant health and environmental conditions under which the product may be used or should not be used;

(l) directions for use and the dose rate, expressed in metric units, for each use provided for under the terms of the approval;

(m) where necessary, the safety interval for each use between application and—

(i) sowing or planting of the crop to be protected;

(ii) sowing or planting of succeeding crops;

(iii) access by humans or animals;

(iv) harvesting; and

(v) use or consumption;

(n) particulars of possible phytotoxicity, varietal susceptibility and any other direct or indirect adverse side effects on plants or products of plant origin together with the intervals to be observed between application and sowing or planting of—

(i) the crop in question; or

(ii) subsequent crops;

(o) if accompanied by a leaflet, as provided for in paragraph 2 below, the sentence “Read accompanying instructions before use”;

(p) directions for safe disposal of the plant protection product and of the packaging;

(q) the expiry date relevant to normal conditions of storage where the shelf life of the product is limited to less than two years;

(r) whether the product is restricted to a certain category of user and, if so, which.

(1)

By J Rigaudy and S P Klesney, published by Pergamon (ISBN 0-08022-3699).

(2)

By R Panico, W H Powell and J-C Richer, published by Blackwell Science (ISBN 0-63203-4882). Corrections published in Pure Appl.Chem., vol. 71, No. 7, pp. 1327-1330, 1999.