Search Legislation

Commission Delegated Regulation (EU) 2018/985Show full title

Commission Delegated Regulation (EU) 2018/985 of 12 February 2018 supplementing Regulation (EU) No 167/2013 of the European Parliament and of the Council as regards environmental and propulsion unit performance requirements for agricultural and forestry vehicles and their engines and repealing Commission Delegated Regulation (EU) 2015/96 (Text with EEA relevance)

 Help about what version

What Version

More Resources

 Help about UK-EU Regulation

Legislation originating from the EU

When the UK left the EU, legislation.gov.uk published EU legislation that had been published by the EU up to IP completion day (31 December 2020 11.00 p.m.). On legislation.gov.uk, these items of legislation are kept up-to-date with any amendments made by the UK since then.

Close

This item of legislation originated from the EU

Legislation.gov.uk publishes the UK version. EUR-Lex publishes the EU version. The EU Exit Web Archive holds a snapshot of EUR-Lex’s version from IP completion day (31 December 2020 11.00 p.m.).

Changes to legislation:

This version of this Regulation was derived from EUR-Lex on IP completion day (31 December 2020 11:00 p.m.). It has not been amended by the UK since then. Find out more about legislation originating from the EU as published on legislation.gov.uk. Help about Changes to Legislation

Close

Changes to Legislation

Revised legislation carried on this site may not be fully up to date. At the current time any known changes or effects made by subsequent legislation have been applied to the text of the legislation you are viewing by the editorial team. Please see ‘Frequently Asked Questions’ for details regarding the timescales for which new effects are identified and recorded on this site.

  1. Introductory Text

  2. CHAPTER I SUBJECT MATTER AND DEFINITIONS

    1. Article 1.Subject matter

    2. Article 2.Definitions

  3. CHAPTER II SUBSTANTIVE REQUIREMENTS

    1. Article 3.Pollutant emissions

    2. Article 4.External sound levels

    3. Article 5.Propulsion performance

  4. CHAPTER III TYPE-APPROVAL PROCEDURES

    1. Article 6.EU type-approval of an agricultural and forestry vehicle with regard to pollutant emissions

    2. Article 7.EU type-approval of an engine or an engine family with regard to pollutant emissions

    3. Article 8.EU type-approval of an agricultural and forestry vehicle with regard to external sound levels

    4. Article 9.Extension of EU type-approvals

    5. Article 10.Subsequent changes affecting the environmental and propulsion unit performance

  5. CHAPTER IV EQUIVALENCE

    1. Article 11.Equivalence of alternative type-approvals

  6. CHAPTER V ACCESS TO VEHICLE REPAIR AND MAINTENANCE INFORMATION

    1. Article 12.Obligation on engine manufacturers

  7. CHAPTER VI FINAL PROVISIONS

    1. Article 13.Transitional provisions

    2. Article 14.Exemptions

    3. Article 15.Repeal

    4. Article 16.Entry into force and application

  8. Signature

    1. ANNEX I

      Requirements for EU type-approval regarding pollutant emissions

      1. PART 1 Adaptation to the requirements laid down in Regulation (EU) 2016/1628...

        1. 1. For the purposes of granting an EU type-approval regarding pollutant...

        2. 2. Engine manufacturers shall use the parameters laid down in Annex...

      2. PART 2 Specific requirements

        1. 1. In addition to the provisions of Article 28 of Regulation...

        2. 2. Marking

          1. 2.1. The engine shall bear a statutory marking in accordance with...

        3. 3. Monitoring of emissions of in-service engines

          1. 3.1. Engine manufacturers shall comply with the requirements on monitoring of...

        4. 4. Engine installation in the vehicle

          1. 4.1. The engine installed in an agricultural and forestry vehicle shall...

          2. 4.2. The engine installation in an agricultural and forestry vehicle shall...

          3. 4.3. The engine manufacturer shall provide to the vehicle manufacturer all...

        5. 5. The engine manufacturer shall make available to the vehicle manufacturer...

        6. 6. Prevention of tampering

          1. 6.1. Engine manufacturers shall apply the provisions concerning technical details laid...

    2. ANNEX II

      Requirements for external sound emissions

      1. 1. Permissible external sound levels

        1. 1.1. The instrumentation system, including the microphones, cables and windscreen shall...

        2. 1.2. Conditions of measurement

          1. 1.2.1. Measurements shall be made on agricultural and forestry vehicles with...

          2. 1.2.2. This area may take the form, for instance, of an...

          3. 1.2.3. The surface of the test track shall be such as...

          4. 1.2.4. Measurement shall be carried out in fine weather with little...

        3. 1.3. Method of measurement

          1. 1.3.1. Measurement of external sound level of agricultural and forestry vehicles...

            1. 1.3.1.1. At least two measurements shall be made on each side...

            2. 1.3.1.2. The microphone shall be situated 1,2 metres above ground level...

            3. 1.3.1.3. Two lines AA′ and BB′, parallel to line PP′ and...

            4. 1.3.1.4. The maximum sound level recorded shall constitute the result of...

              1. Figure 1

            5. 1.3.1.5. The steady speed before approaching line AA′ shall be three...

            6. 1.3.1.6. Interpretation of results

              1. 1.3.1.6.1. To take account of inaccuracies in the measuring instruments, the...

              2. 1.3.1.6.2. Measurements shall be considered valid where the difference between two...

              3. 1.3.1.6.3. The highest sound level measured shall constitute the test result....

          2. 1.3.2. Measurement of external sound with agricultural and forestry vehicle stationary...

            1. 1.3.2.1. Position of sound-level meter

            2. 1.3.2.2. Number of measurements: at least two measurements shall be made....

            3. 1.3.2.3. Agricultural and forestry vehicle test conditions

              1. 1.3.2.3.1. The engine of an agricultural and forestry vehicle without a...

              2. 1.3.2.3.2. Before taking any measurements, the engine shall be brought to...

            4. 1.3.2.4. Interpretation of results

              1. 1.3.2.4.1. All external sound-level readings recorded shall be given in the...

              2. 1.3.2.4.2. The measurements shall be considered valid where the difference between...

              3. 1.3.2.4.3. The maximum figure recorded shall constitute the result of the...

          3. 1.3.3. External sound testing provisions for C-category vehicles with track chains...

      2. 2. Exhaust system (Silencer)

        1. 2.1. Where the agricultural and forestry vehicle is fitted with a...

          1. Figure 2 Measuring positions for stationary agricultural and forestry vehicles

        2. 2.2. A drawing of the exhaust system must be annexed to...

        3. 2.3. The silencer must be marked with a reference to its...

        4. 2.4. The use of fibrous absorbent material is permitted in the...

Back to top

Options/Help

Print Options

Close

Legislation is available in different versions:

Latest Available (revised):The latest available updated version of the legislation incorporating changes made by subsequent legislation and applied by our editorial team. Changes we have not yet applied to the text, can be found in the ‘Changes to Legislation’ area.

Original (As adopted by EU): The original version of the legislation as it stood when it was first adopted in the EU. No changes have been applied to the text.

Close

Opening Options

Different options to open legislation in order to view more content on screen at once

Close

More Resources

Access essential accompanying documents and information for this legislation item from this tab. Dependent on the legislation item being viewed this may include:

  • the original print PDF of the as adopted version that was used for the EU Official Journal
  • lists of changes made by and/or affecting this legislation item
  • all formats of all associated documents
  • correction slips
  • links to related legislation and further information resources
Close

Timeline of Changes

This timeline shows the different versions taken from EUR-Lex before exit day and during the implementation period as well as any subsequent versions created after the implementation period as a result of changes made by UK legislation.

The dates for the EU versions are taken from the document dates on EUR-Lex and may not always coincide with when the changes came into force for the document.

For any versions created after the implementation period as a result of changes made by UK legislation the date will coincide with the earliest date on which the change (e.g an insertion, a repeal or a substitution) that was applied came into force. For further information see our guide to revised legislation on Understanding Legislation.

Close

More Resources

Use this menu to access essential accompanying documents and information for this legislation item. Dependent on the legislation item being viewed this may include:

  • the original print PDF of the as adopted version that was used for the print copy
  • correction slips

Click 'View More' or select 'More Resources' tab for additional information including:

  • lists of changes made by and/or affecting this legislation item
  • confers power and blanket amendment details
  • all formats of all associated documents
  • links to related legislation and further information resources