Directive 2009/138/EC of the European Parliament and of the CouncilDangos y teitl llawn

Article 104 U.K. Design of the Basic Solvency Capital Requirement

1. The Basic Solvency Capital Requirement shall comprise individual risk modules, which are aggregated in accordance with point (1) of Annex IV.

It shall consist of at least the following risk modules:

(a) non-life underwriting risk;

(b) life underwriting risk;

(c) health underwriting risk;

(d) market risk;

(e) counterparty default risk.

2. For the purposes of points (a), (b) and (c) of paragraph 1, insurance or reinsurance operations shall be allocated to the underwriting risk module that best reflects the technical nature of the underlying risks.

3. The correlation coefficients for the aggregation of the risk modules referred to in paragraph 1, as well as the calibration of the capital requirements for each risk module, shall result in an overall Solvency Capital Requirement which complies with the principles set out in Article 101.

4. Each of the risk modules referred to in paragraph 1 shall be calibrated using a Value-at-Risk measure, with a 99,5 % confidence level, over a one-year period.

Where appropriate, diversification effects shall be taken into account in the design of each risk module.

5. The same design and specifications for the risk modules shall be used for all insurance and reinsurance undertakings, both with respect to the Basic Solvency Capital Requirement and to any simplified calculations as laid down in Article 109.

6. With regard to risks arising from catastrophes, geographical specifications may, where appropriate, be used for the calculation of the life, non-life and health underwriting risk modules.

7. Subject to approval by the supervisory authorities, insurance and reinsurance undertakings may, within the design of the standard formula, replace a subset of its parameters by parameters specific to the undertaking concerned when calculating the life, non-life and health underwriting risk modules.

Such parameters shall be calibrated on the basis of the internal data of the undertaking concerned, or of data which is directly relevant for the operations of that undertaking using standardised methods.

When granting supervisory approval, supervisory authorities shall verify the completeness, accuracy and appropriateness of the data used.