- Latest available (Revised)
- Original (As made)
This is the original version (as it was originally made).
Regulation 12
1. The references in the tables to categories of modules are the following:
=
Module A
=
Modules A1, D1, E1
=
Modules B1+D, B1+F, B+E, B+C1, H
=
Modules B+D, B+F, G, H1
2. The safety accessories defined in Article 1, Section 2.1.3, and referred to in Article 3, Section 1.4, are classified in category IV. However, by way of exception, safety accessories manufactured for specific equipment may be classified in the same category as the equipment they protect.
3. The pressure accessories defined in Article 1, Section 2.1.4, and referred to in Article 3, Section 1.4, are classified on the basis of:
their maximum allowable pressure PS, and
their volume V or their nominal size DN, as appropriate, and
the group of fluids for which they are intended,
and the appropriate table for vessels or piping is to be used to determine the conformity assessment category.
Where both the volume and the nominal size are considered appropriate in the second indent, the pressure accessory must be classified in the highest category.
4. The demarcation lines in the following conformity assessment tables indicate the upper limit for each category.
Table 1
Vessels referred to in Article 3, Section 1.1(a), first indent
Exceptionally, vessels intended to contain an unstable gas and falling within categories I or II on the basis of Table 1 must be classified in category III.
Table 2
Vessels referred to in Article 3, Section 1.1(a), second indent
Exceptionally, portable extinguishers and bottles for breathing equipment must be classified at least in category III
Table 4
Vessels referred to in Article 3, Section 1.1(b), second indent
Exceptionally, assemblies intended for generating warm water as referred to in Article 3, Section 2.3, must be subject either to an EC design examination (Module B1) with respect to their conformity with the essential requirements referred to in Sections 2.10, 2.11, 3.4, 5(a) and 5(d) of Annex I, or to full quality assurance (Module H).
Table 5
Pressure equipment referred to in Article 3, Section 1.2
Exceptionally, the design of pressure-cookers must be subject to a conformity assessment procedure equivalent to at least one of the category III modules.
Table 6
Piping referred to in Article 3, Section 1.3(a), first indent
Exceptionally, piping intended for unstable gases and falling within categories I or II on the basis of Table 6 must be classified in category III.
Latest Available (revised):The latest available updated version of the legislation incorporating changes made by subsequent legislation and applied by our editorial team. Changes we have not yet applied to the text, can be found in the ‘Changes to Legislation’ area.
Original (As Enacted or Made): The original version of the legislation as it stood when it was enacted or made. No changes have been applied to the text.
Access essential accompanying documents and information for this legislation item from this tab. Dependent on the legislation item being viewed this may include: