Directive 2005/55/EC of the European Parliament and of the Council (repealed)Show full title

1. ENGINE MAPPING PROCEDURE U.K.

1.1. Determination of the mapping speed range U.K.

For generating the ETC on the test cell, the engine needs to be mapped prior to the test cycle for determining the speed vs torque curve. The minimum and maximum mapping speeds are defined as follows:

Minimum mapping speed

=

idle speed

Maximum mapping speed

=

n_hi × 1,02 or speed where full load torque drops off to zero, whichever is lower

1.2. Performing the engine power map U.K.

The engine shall be warmed up at maximum power in order to stabilise the engine parameters according to the recommendation of the manufacturer and good engineering practice. When the engine is stabilised, the engine map shall be performed as follows:

(a)

the engine shall be unloaded and operated at idle speed;

(b)

the engine shall be operated at full load setting of the injection pump at minimum mapping speed;

(c)

the engine speed shall be increased at an average rate of 8 ± 1 min^-1 /s from minimum to maximum mapping speed. Engine speed and torque points shall be recorded at a sample rate of a least one point per second.

1.3. Mapping curve generation U.K.

All data points recorded under Section 1.2 shall be connected using linear interpolation between points. The resulting torque curve is the mapping curve and shall be used to convert the normalised torque values of the engine cycle into actual torque values for the test cycle, as described in Section 2.

1.4. Alternate mapping U.K.

If a manufacturer believes that the above mapping techniques are unsafe or unrepresentative for any given engine, alternate mapping techniques may be used. These alternate techniques must satisfy the intent of the specified mapping procedures to determine the maximum available torque at all engine speeds achieved during the test cycles. Deviations from the mapping techniques specified in this section for reasons of safety or representativeness shall be approved by the Technical Service along with the justification for their use. In no case, however, shall descending continual sweeps of engine speed be used for governed or turbocharged engines.

1.5. Replicate tests U.K.

An engine need not be mapped before each and every test cycle. An engine shall be remapped prior to a test cycle if:

• an unreasonable amount of time has transpired since the last map, as determined by engineering judgement,

  or

• physical changes or recalibrations have been made to the engine which may potentially affect engine performance.