SCHEDULE 2AMENDMENTS TO COMMISSION REGULATIONS RELATED TO ECODESIGN
Commission Regulation (EU) No 1253/201423
1
Commission Regulation (EU) No 1253/2014 of 7 July 2014 implementing Directive 2009/125/EC of the European Parliament and of the Council with regard to ecodesign requirements for ventilation units is amended as follows.
2
In Article 1, in subparagraph 2(d), after “Council”, insert “, as it had effect immediately before exit day”.
3
In Article 2 (definitions), at the beginning, for “For the purposes of this Regulation the following definitions shall apply:”, substitute—
The definitions set out in the Ecodesign for Energy-Related Products Regulations 2010 apply; and for any term that is not defined in those Regulations, the definitions set out in Directive 2009/125/EC of the European Parliament and of the Council of 21 October 2009 establishing a framework for the setting of ecodesign requirements for energy-related products, as it had effect immediately before exit day, apply. The following definitions also apply—
4
In Article 5 (conformity assessment), in paragraph 1, for the words from “Manufacturers of ventilation” to “Annex V to that Directive”, substitute—
1
For the purposes of regulation 4(2)(a) of the Ecodesign for Energy-Related Products Regulations 2010, the procedure for assessing whether an energy-related product complies with this implementing measure is the internal design control system set out in Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010 or the management system for assessing conformity set out in Part 2 of Schedule 1A to those Regulations.
5
For Article 6 (verification procedure for market surveillance purposes) substitute—
When performing market surveillance checks to assess compliance with the requirements set out for RVUs in Annex 2 and for NRVUs in Annex 3 the authorities of the United Kingdom must apply the verification procedure described in Annex 6.
6
In Article 7 (benchmarks), omit “referred to in point (2) of Part 3 of Annex 1 to Directive 2009/125/EC”.
7
Article 8 (review) is omitted.
8
At the end of Article 9 (entry into force), omit “This Regulation shall be binding in its entirety and directly applicable in all Member States.”.
9
Annex 6 (product compliance verification by market surveillance authorities) is amended as follows—
a
in each instance, for “Member State” or “Member States”, substitute “United Kingdom”;
b
for the second paragraph, substitute—
When verifying the compliance of a product model with the requirements laid down in this Regulation, for the requirements referred to in this Annex the authorities of the United Kingdom must apply the following procedure—
c
in subparagraph (2)(a)—
i
for “point 2 of Annex IV to Directive 2009/125/EC (declared values)” substitute “paragraph 1(2) of Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010”; and
ii
for “paragraph (g) thereof”, substitute “paragraph 1(2)(b)(vii) of Part 1 of Schedule 1A to those Regulations”;
d
subparagraph (6) is omitted; and
e
in the fourth paragraph—
i
for “6” substitute “5”; and
ii
for “harmonised” substitute “designated”.