17.—(1) Commission Regulation (EU) No 617/2013 of 26 June 2013 implementing Directive 2009/125/EC of the European Parliament and of the Council with regard to ecodesign requirements for computers and computer servers is amended as follows.
(2) In Article 2 (definitions), at the beginning, for “The following definitions shall apply:”, substitute—
“The definitions set out in the Ecodesign for Energy-Related Products Regulations 2010 apply; and for any term that is not defined in those Regulations, the definitions set out in Directive 2009/125/EC of the European Parliament and of the Council of 21 October 2009 establishing a framework for the setting of ecodesign requirements for energy-related products, as it had effect immediately before exit day, apply. The following definitions also apply—”.
(3) For Article 6 (conformity assessment), substitute—
“For the purposes of regulation 4(2)(a) of the Ecodesign for Energy-Related Products Regulations 2010, the procedure for assessing whether an energy-related product complies with this implementing measure is the internal design control system set out in Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010 or the management system for assessing conformity set out in Part 2 of Schedule 1A to those Regulations.”.
(4) In Article 7 (market surveillance and verification procedure), for “Directive 2009/125/EC”, substitute “the Ecodesign for Energy-Related Products Regulations 2010”.
(5) Omit Article 9 (revision).
(6) At the end of Article 10 (entry into force and application), omit “This Regulation shall be binding in its entirety and directly applicable in all Member States.”.
(7) Annex 3 (measurements by market surveillance authorities and product compliance verification by market surveillance authorities) is amended as follows—
(a)in each instance, for “Member State” or “Member States”, substitute “United Kingdom”;
(b)in section 1 (measurements), in the first paragraph, for the words from “harmonised” to “Union”, substitute “designated standards”;
(c)in section 2 (product compliance verification by market surveillance authorities)—
(i)for the first paragraph, substitute—
“When verifying the compliance of a product model with the requirements laid down in this Regulation, for the requirements referred to in this Annex the authorities of the United Kingdom must apply the following procedure—”;
(ii)in subparagraph (2)(a)—
(aa)for “point 2 of Annex IV to Directive 2009/125/EC (declared values)”, substitute “paragraph 1(2) of Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010”; and
(bb)for “paragraph (g) thereof”, substitute “paragraph 1(2)(b)(vii) of Part 1 of Schedule 1A to those Regulations”;
(iii)omit subparagraph (7); and
(iv)in the third paragraph, for “7” substitute “6”.
(8) In Annex 4 (indicative benchmarks), for “purpose of Part 3, point 2 of Annex I to Directive 2009/125/EC” substitute “purposes of this Regulation”.