The Smoke Control Areas (Authorised Fuels) (Amendment) Regulations 1998

Authorised fuels for the purposes of the Clean Air Act 1993

2.  Schedule 1 to the Smoke Control Areas (Authorised Fuels) Regulations 1991(1) shall be amended as follows:

(a) after paragraph 1 there shall be inserted–

“1A.   Aimcor Excel briquettes, manufactured by Applied Industrial Materials UK Limited at Newfield, Co. Durham, which–

(a) comprise petroleum coke (as to 60 per cent to 75 per cent of the total weight), low volatile coal and reactive coke (as to 20 per cent to 25 per cent of the total weight) and cold-setting resin binder (as to the remaining weight);

(b) were manufactured from those constituents by a process involving roll pressing;

(c) are unmarked pillow-shaped briquettes and have an average weight of 73 grammes; and

(d) have a sulphur content not exceeding 2 per cent of the total weight.”;

(b) for paragraph 4B(2) there shall be substituted–

“4B.   BFL Fireside, which are marketed by British Fuels Limited and are the same as Supertherm briquettes as described in paragraph 18 below.”;

(c) paragraph 13B(3) shall be revoked;

(d) after paragraph 14 there shall be inserted–

“14A.   Newflame briquettes, manufactured by Maxibrite Limited, at Llantrisant, Mid-Glamorgan, which–

(a) comprise anthracite (as to approximately 75 per cent of the total weight), petroleum coke (as to approximately 21 per cent of the total weight) and starch with a catalyst as binder (as to the remaining weight);

(b) were manufactured from those constituents by a process involving roll pressing and heat treatment at about 250°C;

(c) are unmarked pillow-shaped briquettes and have an average weight of 78 grammes; and

(d) have a sulphur content not exceeding 2 per cent of the total weight.”;

(e) after paragraph 16A(4) there shall be inserted–

“16B.   Safelight Firelogs, manufactured by Advanced Natural Fuels Limited, at Pocklington, East Yorkshire, which–

(a) comprise woodchip (as to approximately 40 per cent to 55 per cent of the total weight) and Palm Wax binder (as to approximately 45 per cent to 60 per cent of the total weight);

(b) were manufactured from those constituents by a process involving pressing of the mixed ingredients at about 40° to 50°C;

(c) are rectangular hard finish Firelogs with two deep overlapping slots in the top surface, a single continuous slot in the base surface, and have an average weight of 1.8 kilogrammes; and

(d) have a sulphur content not exceeding 2 per cent of the total weight.”.

(1)

S.I. 1991/1282, amended by S.I. 1992/72, 3148, 1993/2499, 1996/1145 and 1997/2658.

(2)

Paragraph 4B was inserted by regulation 2(3) of S.I. 1993/2499.

(3)

Paragraph 13B was inserted by regulation 2(3) of S.I. 1992/72.

(4)

Paragraph 16A was inserted by regulation 2(5) of S.I. 1992/72 and amended by regulation 2(8) of S.I. 1993/2499.