Commission Regulation (EC) No 278/2009
5.—(1) Commission Regulation (EC) No 278/2009 of 6 April 2009 implementing Directive 2005/32/EC of the European Parliament and of the Council with regard to ecodesign requirements for no-load condition electric power consumption and average active efficiency of external power supplies is amended as follows.
(2) In Article 2 (definitions), at the beginning, for the words from “For the purposes” to “also apply:”, substitute—
“The definitions set out in the Ecodesign for Energy-Related Products Regulations 2010 apply; and for any term that is not defined in those Regulations, the definitions set out in Directive 2009/125/EC of the European Parliament and of the Council of 21 October 2009 establishing a framework for the setting of ecodesign requirements for energy-related products, as it had effect immediately before exit day, apply. The following definitions also apply—”.
(3) For Article 4 (conformity assessment), substitute—
“For the purposes of regulation 4(2)(a) of the Ecodesign for Energy-Related Products Regulations 2010, the procedure for assessing whether an energy-related product complies with this implementing measure is the internal design control system set out in Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010 or the management system for assessing conformity set out in Part 2 of Schedule 1A to those Regulations.”.
(4) Omit Article 7 (revision).
(5) At the end of Article 9 (entry into force), omit “This Regulation shall be binding in its entirety and directly applicable in all Member States.”.
(6) Annex 2 (product compliance verification by market surveillance authorities) is amended as follows—
(a)in each instance, for “Member State” or “Member States” substitute “United Kingdom”;
(b)for the second paragraph, substitute—
“When verifying the compliance of a product model with the requirements laid down in this Regulation, for the requirements referred to in this Annex the authorities of the United Kingdom must apply the following procedure—”;
(c)in subparagraph (2)(a)—
(i)for “point 2 of Annex IV to Directive 2009/125/EC (declared values)” substitute “paragraph 1(2) of Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010”; and
(ii)for “paragraph (g) thereof”, substitute “paragraph 1(2)(b)(vii) of Part 1 of Schedule 1A to those Regulations”;
(d)subparagraph (7) is omitted;
(e)in the fourth paragraph—
(i)for “7” substitute “6”; and
(ii)for “harmonised” substitute “designated”.