SCHEDULE 2AMENDMENTS TO COMMISSION REGULATIONS RELATED TO ECODESIGN
Commission Regulation (EC) No 278/20095
1
Commission Regulation (EC) No 278/2009 of 6 April 2009 implementing Directive 2005/32/EC of the European Parliament and of the Council with regard to ecodesign requirements for no-load condition electric power consumption and average active efficiency of external power supplies is amended as follows.
2
In Article 2 (definitions), at the beginning, for the words from “For the purposes” to “also apply:”, substitute—
The definitions set out in the Ecodesign for Energy-Related Products Regulations 2010 apply; and for any term that is not defined in those Regulations, the definitions set out in Directive 2009/125/EC of the European Parliament and of the Council of 21 October 2009 establishing a framework for the setting of ecodesign requirements for energy-related products, as it had effect immediately before exit day, apply. The following definitions also apply—
3
For Article 4 (conformity assessment), substitute—
For the purposes of regulation 4(2)(a) of the Ecodesign for Energy-Related Products Regulations 2010, the procedure for assessing whether an energy-related product complies with this implementing measure is the internal design control system set out in Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010 or the management system for assessing conformity set out in Part 2 of Schedule 1A to those Regulations.
4
Omit Article 7 (revision).
5
At the end of Article 9 (entry into force), omit “This Regulation shall be binding in its entirety and directly applicable in all Member States.”.
6
Annex 2 (product compliance verification by market surveillance authorities) is amended as follows—
a
in each instance, for “Member State” or “Member States” substitute “United Kingdom”;
b
for the second paragraph, substitute—
When verifying the compliance of a product model with the requirements laid down in this Regulation, for the requirements referred to in this Annex the authorities of the United Kingdom must apply the following procedure—
c
in subparagraph (2)(a)—
i
for “point 2 of Annex IV to Directive 2009/125/EC (declared values)” substitute “paragraph 1(2) of Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010”; and
ii
for “paragraph (g) thereof”, substitute “paragraph 1(2)(b)(vii) of Part 1 of Schedule 1A to those Regulations”;
d
subparagraph (7) is omitted;
e
in the fourth paragraph—
i
for “7” substitute “6”; and
ii
for “harmonised” substitute “designated”.