SCHEDULE 2AMENDMENTS TO COMMISSION REGULATIONS RELATED TO ECODESIGN

Commission Regulation (EC) No 107/20092

1

Commission Regulation (EC) No 107/2009 of 4 February 2009 implementing Directive 2005/32/EC of the European Parliament and of the Council with regard to ecodesign requirements for simple set-top boxes is amended as follows.

2

In Article 2 (definitions), at the beginning, for the words from “For the purposes” to “also apply:”, substitute—

The definitions set out in the Ecodesign for Energy-Related Products Regulations 2010 apply; and for any term that is not defined in those Regulations, the definitions set out in Directive 2009/125/EC of the European Parliament and of the Council of 21 October 2009 establishing a framework for the setting of ecodesign requirements for energy-related products, as it had effect immediately before exit day, apply. The following definitions also apply—

3

For Article 5 (conformity assessment), substitute—

For the purposes of regulation 4(2)(a) of the Ecodesign for Energy-Related Products Regulations 2010, the procedure for assessing whether an energy-related product complies with this implementing measure is the internal design control system set out in Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010 or the management system for assessing conformity set out in Part 2 of Schedule 1A to those Regulations.

4

Omit Article 8 (revision).

5

At the end of Article 9 (entry into force), omit “This Regulation shall be binding in its entirety and directly applicable in all Member States.”.

6

Annex 2 (product compliance verification by market surveillance authorities) is amended as follows—

a

in each instance, for “Member State” or “Member States”, substitute “United Kingdom”;

b

for the second paragraph, substitute—

When verifying the compliance of a product model with the requirements laid down in this Regulation, for the requirements referred to in this Annex the authorities of the United Kingdom must apply the following procedure—

c

in subparagraph (2)(a)—

i

for “point 2 of Annex IV to Directive 2009/125/EC (declared values)” substitute “paragraph 1(2) of Part 1 of Schedule 1A to the Ecodesign for Energy-Related Products Regulations 2010”; and

ii

for “paragraph (g) thereof”, substitute “paragraph 1(2)(b)(vii) of Part 1 of Schedule 1A to those Regulations”;

d

subparagraph (7) is omitted;

e

in the fourth paragraph—

i

for “7” substitute “6”; and

ii

for “harmonised” substitute “designated”.

7

In Annex 3 (benchmarks), in the first paragraph, for “purpose of Annex I, part 3, point 2, of Directive 2005/32/EC” substitute “purposes of this Regulation”.