In the case of three additional units tested as prescribed in Annex IV point 2(a), the determined value means the arithmetic mean of the values determined for these three additional units.,

On mode power demand, ( P measured  , Watts) excluding allowances and adjustments in Annex II, point B, for the purposes of EEI calculation set out in Annex II, point A.,The determined value shall not exceed the declared value by more than 7 %,
Off mode, standby mode and networked standby mode power demand (Watts), as applicable,The determined value shall not exceed the declared value by more than 0,1 Watt if the declared value is 1,0 W or less, or by more than 10 % if the declared value is more than 1,0 W,
Peak white luminance ratio,Where applicable, the determined value shall not be lower than 60 % of the peak white luminance of the brightest on mode configuration provided by the electronic display,
Peak white luminance (cd/m 2 ),The determined value shall not be lower than the declared value by more than 8 %,
Visible screen diagonal in centimetres (and inches, if declared),The determined value shall not be lower than the declared value by more than 1 cm (or 0,4 inches).,
Screen area in dm 2 ,The determined value shall not be lower than the declared value by more than 0,1 dm 2 ,
Timed functions as set out in Annex II, points C.3 and C.4,The switch shall be completed within 5 seconds of the set out values,
Weight of plastic components as qualified in Annex II, point D.2,The determined value shall not be different from the declared value by more than 5 grams,