xmlns:atom="http://www.w3.org/2005/Atom"
After every inspection by an approved fitter or workshop, a new plaque shall be affixed in place of the previous one.
name, address or trade name of the approved fitter or workshop,
characteristic coefficient of the vehicle, in the form ‘w = … imp/km’,
constant of the recording equipment, in the form ‘k = … imp/km’,
effective circumference of the wheel tyres in the form ‘l = … mm’,
tyre size,
the date on which the characteristic coefficient of the vehicle and the effective circumference of the wheel tyres were measured,
the vehicle identification number,
the presence (or not) of an external GNSS facility,
the serial number of the external GNSS facility,
the serial number of the remote communication device,
the serial number of all the seals in place,
the part of the vehicle where the adaptor, if any, is installed,
the part of the vehicle where the motion sensor is installed, if not connected to the gear-box or an adaptor is not being used,
a description of the colour of the cable between the adaptor and that part of the vehicle providing its incoming impulses,
the serial number of the embedded motion sensor of the adaptor.
This second, additional plaque, if used, shall be affixed next to or beside the first primary plaque described in Requirement 396, and shall have the same protection level. Furthermore the secondary plaque shall also bear the name, address or trade name of the approved fitter or workshop that carried out the installation, and the date of installation.
Commission Regulation (EC) No 68/2009 of 23 January 2009 adapting for the ninth time to technical progress Council Regulation (EEC) No 3821/85 on recording equipment in road transport (OJ L 21, 24.1.2009, p. 3).