ANNEX I CU.K.Requirements for construction, testing, installation, and inspection
Appendix 15
MIGRATION: MANAGING THE CO-EXISTENCE OF EQUIPMENT GENERATIONS U.K.
1.DEFINITIONSU.K.
For the purposes of this Appendix, the following definitions are used.
as defined by this Annex (chapter 1: definition bbb);
as defined by this Regulation (article 2: definition 1);
as defined by this Regulation (article 2: definition 7);
as defined by this Annex (chapter 1: definition ccc);
equipment used to perform data downloading, as defined in Appendix 7 of this Annex.
2.GENERAL PROVISIONSU.K.
2.1. Overview of the transition U.K.
The preamble of this Annex provides an overview of the transition between the first and the second generation tachograph systems.
In addition to the provisions of this preamble:
first generation motion sensors will not be interoperable with second generation vehicle units.
second generation motion sensors will start to be installed in vehicles at the same time as second generation vehicle units.
data download and calibration equipment will need to evolve, in order to support use of both generation of recording equipment and tachograph cards.
2.2. Interoperability between VU and cards U.K.
[F1It is understood that first generation tachograph cards are interoperable with first generation vehicle units in compliance with Annex IB to Regulation (EEC) No 3821/85, while second generation tachograph cards are interoperable with second generation vehicle units in compliance with Annex IC to this Regulation. In addition, the requirements below shall apply.]
Textual Amendments
MIG_001Except as provided for in requirement MIG_004 and MIG_005, first generation tachograph cards may continue to be used in second generation vehicle units until their end of validity date. Their holders may however ask for their replacement by second generation tachograph cards as soon as they are available.U.K.
MIG_002Second generation vehicle units shall be able to use any valid first generation driver, control and company card inserted.U.K.
MIG_003This capability may be suppressed once and forever in such vehicle units by workshops, so that first generation tachograph cards cannot be accepted anymore. This may only be done after the European Commission has launched a procedure aiming to request workshops to do so, for example during each periodic inspection of tachograph.U.K.
MIG_004Second generation vehicle units shall only be able to use second generation workshop cards.U.K.
MIG_005For determining the mode of operation, second generation vehicle units shall only consider the types of the valid cards inserted, regardless of their generations.U.K.
MIG_006Any valid second generation tachograph card shall be able to be used in first generation vehicle units exactly the same manner as a first generation tachograph card of the same type.U.K.
2.3. Interoperability between VU and MS U.K.
It is understood that first generation motion sensors are interoperable with first generation vehicle units, while second generation motion sensors are interoperable with second generation vehicle units. In addition, the requirements below shall apply.
MIG_007Second generation vehicle units will not be able to be paired and used with first generation motion sensors.U.K.
MIG_008Second generation motion sensors may be paired and used with second generation vehicle units only, or with both generations of vehicle units.U.K.
2.4. Interoperability between vehicle units, tachograph cards and equipment for data download U.K.
MIG_009Equipment for data download may be used with one generation only of vehicle units and tachograph cards, or with both.U.K.
2.4.1 Direct card download by IDE U.K.
MIG_010Data shall be downloaded by IDE from tachograph cards of one generation inserted in their card readers, using the security mechanisms and the data download protocol of this generation, and downloaded data shall have the format defined for this generation.U.K.
MIG_011To allow drivers' control by non EU control authorities, it shall also be possible to download second generation driver (and workshop) cards exactly the same manner as 1st generation drivers (and workshop) cards. Such download shall include:U.K.
[F1non signed EFs IC and ICC (optional),]
[F1the other application data EFs (within DF Tachograph) requested by the first generation card download protocol. This information shall be secured with a digital signature, according to the first generation security mechanisms.
Such download shall not include application data EFs only present in second generation driver (and workshop) cards (application data EFs within DF Tachograph_G2).]