xmlns:atom="http://www.w3.org/2005/Atom" xmlns:atom="http://www.w3.org/2005/Atom"

ANNEX IU.K. Template for the information document and for the information folder

[F1Appendix 24

Textual Amendments

Manufacturer’s declaration on anti-tampering of powertrain and speed-limitation device U.K.

Manufacturer’s declaration on anti-tampering of powertrain and speed-limitation device U.K.

A duly-completed version of this statement shall be included in the information folder.

The undersigned: [… (full name and position)]

2.3. Company name and address of manufacturer: … U.K.
2.3.2. Name and address of the manufacturer’s authorised representative (if any) (1) : … U.K.

Hereby declares that:

2.1. Make(s) (trade name(s) of manufacturer: … U.K.
2.4.1.

Type (2) : …

2.4.2.

Variant(s) (2) : …

2.4.3.

Version(s) (2) : …

2.4.4

Commercial name(s) (if available): …

2.4.5.

Category, subcategory and speed index of vehicle (3) : …

Will not market interchangeable components which could involve an increase in the propulsion performance of the vehicle variant

Place: … Date: …

Signature: … Name and position in the company: …

Explanatory notes relating to Appendix 24 (Footnote markers, footnotes and explanatory notes not to be stated on the Manufacturer’s declaration)] U.K.
Explanatory notes relating to the information document U.K. (Footnote markers, footnotes and explanatory notes not to be stated on the data entries) U.K.
(1)For tyres type-approved in accordance with the requirements laid down in section 2 of Annex XXX to Commission Delegated Regulation (EU) 2015/208 or approved in accordance with UNECE Regulation No 106, indicate the ‘Rolling radius, expressed by the speed radius index’; for tyres approved under UNECE Regulation No 54 or UNECE Regulation No 75 indicate the ‘Nominal Rolling Circumference’.U.K.
(2)Classified according to Article 4 of Regulation (EU) No 167/2013, the coding shall be indicated, e.g. ‘T4.3a’ for a low-clearance tractor with a maximum design speed below or equal to 40 km/h.U.K.
(3)Delete the entry if not applicable.U.K.
(4)Delete where not applicable (no deletion required when more than one value is applicable).U.K.
(5)Indicate the configuration by following codes:U.K.
— R

:

right side of the vehicle

— L

:

left side of the vehicle

— F

:

front side of the vehicle

— RE

:

rear side of the vehicle

Example for a vehicle with 2 left-side doors and 1 right-side door:

2 L, 1R

[F2( 6 ) For engines, indicate the engine type designation or, in case of engine types within an engine family, the Family Type (FT) in accordance with point 4 of Part B of Annex I to Commission Implementing Regulation (EU) 2017/656. U.K.

Textual Amendments

( 7 ) Indicate the category and sub-category of the engine in accordance with Article 4 and Annex I to Regulation (EU) 2016/1628.] U.K.
(8)Indicate the position by the following codes:U.K.
— Rx

:

row number

— R

:

right side of the vehicle

— C

:

centre of the vehicle

— L

:

left side of the vehicle

Example for a vehicle with a second row with 1 passenger seat on the left side of the vehicle:

r2: 1L

[F2( 9 ) Indicate the fuel type by the following codes: U.K.
B5

:

Diesel (non-road gas-oil)

E85

:

Ethanol

ED95

:

Ethanol for dedicated compression ignition engines

E10

:

Petrol

NG

:

Natural gas/Biomethane

LPG

:

Liquid Petroleum Gas

O (…)

:

Other (specify)

The Sub Fuel type by the following codes (only for Natural gas/Biomethane):

U

:

Universal fuel — high calorific fuel (H-gas) and low calorific fuel (L-gas)

RH

:

Restricted fuel — high calorific fuel (H-gas)

RL

:

Restricted fuel — low calorific fuel (L-gas)

LNG

:

Fuel specific

The fuelling arrangement by the following codes:

L

:

Liquid-fuel only

G

:

Gaseous-fuel only

D1A

:

Dual-fuel type 1A

D1B

:

Dual-fuel type 1B

D2A

:

Dual-fuel type 2A

D2B

:

Dual-fuel type 2B

D3B

:

Dual-fuel type 3B]

(10)For EU whole-vehicle type-approval, describe the manifold installed on the vehicle; for EU type-approval of an engine/engine family as a component/STU, describe one of the possible manifolds that can be installed on the engine.U.K.
[F3( 11 ) Excluding SLI batteries that supply electric energy for starting, lighting and ignition.] U.K.

Textual Amendments

[F4( 12 )] [ F4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .] U.K.

Textual Amendments

(13)The specified particulars are to be given for any proposed variants.U.K.
[F1( 14 ) ‘A’: for a three-point belt; U.K.

‘ B ’ : for a lap belt;

‘ S ’ : for special types of belt (in this case provide specific information on the nature of these types under observation in entry 53.4.1.);

‘ Ar ’ , ‘ Br ’ or‘Sr’: for a belt incorporating an inertia reel retractor;

‘ Are ’ , ‘ Bre ’ and ‘ Sre ’ : for a belt equipped with an inertia reel retractor and an energy-absorption device on at least one anchorage.]

[F3( 15 ) Only applicable to T- and C-category vehicles authorized to tow R- or S-category vehicles if fitted with a hydraulic energy storage device. U.K.
( 16 ) Indicate the maximum towable mass on the lower link arms of the rear three-point lifting mechanism or the rear three-point lifting mechanism itself, as declared by the manufacturer.] U.K.
(17)Indicate the alphanumeric code Type-Variant-Version or ‘TVV’ allocated to each type, variant and version as set out in point 2.3 of Part B of Annex I to this Regulation. For the identification of variant and versions it may be employed the matrix set out in point 2.2 of Part B of Annex I to this Regulation.U.K.
(18)In case of multi-stage approval, supply this information for each stage.U.K.
(19)Provide this information for each component and separate technical unit installed in the vehicle or system.U.K.
(21)Provide this information for each vehicle type/system.U.K.
(22)Powered and braked track rollers:U.K.
F

:

front

R

:

rear

F & R

:

front and rear

C

:

continuous track

Examples:

— rear powered track rollers

:

R

— Continuous track braked

:

C

(23)Axles with twinned wheels/steered/powered/braked:U.K.
F

:

front

R

:

rear

A

:

articulated vehicles

F & R

:

front and rear

F & A

:

front and articulated

A & R

:

articulated and rear

F & A & R

:

front, articulated and rear

Examples:

— front twinned wheels

:

F

— front and articulated steering

:

F & A

— rear powered axles

:

R

— front and rear braked axles

:

F & R

[F4 [F1( 24 ) Indicate the type of gear shift system(s) by the following codes:] ] U.K.

[ F4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

F4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

F4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

F4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

F4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

F4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .]

[F2( 26 ) Indicate the layout of the cylinders by the following codes: U.K.
LI

:

in line

V

:

in V

O

:

opposed

S

:

single

R

:

radial

O (…)

:

other (specify)]

[F4( 29 )] [ F4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .] U.K.
(30)Serving as a reference point for the various delegated acts. Including the roll-over protection structure, excluding optional accessories, but with coolant, lubricants, fuel, tools and driver The mass of the driver shall be assumed to be 75 kg.U.K.
(31)Standard ISO 612/-6.1:1978 (Road vehicles — Dimensions of motor vehicles and towed vehicles — Terms and definitions).U.K.
(32)Standard ISO 612/-6.2:1978 (Road vehicles — Dimensions of motor vehicles and towed vehicles — Terms and definitions).U.K.
(33)Standard ISO 612/-6.3:1978 (Road vehicles — Dimensions of motor vehicles and towed vehicles — Terms and definitions). For vehicles with height adjustable suspension, state the normal running position.U.K.
(34)Standard ISO 612/-6.6:1978 (Road vehicles — Dimensions of motor vehicles and towed vehicles — Terms and definitions).U.K.
(35)Standard ISO 612/-6.7:1978 (Road vehicles — Dimensions of motor vehicles and towed vehicles — Terms and definitions).U.K.
(36)Standard ISO 612/-6.8:1978 (Road vehicles — Dimensions of motor vehicles and towed vehicles — Terms and definitions).U.K.
(37)for tractors and drawbar R- or S-category vehicles, wheelbase is the distance from first to last axle; for rigid drawbar and centre-axle R- or S-category vehicles, is the distance from centre of front coupling point to last axle.U.K.
(38)Standard ISO 4004:1983 (Agricultural tractors and machinery — Track widths).U.K.
[F4( 39 ) [ F4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . U.K.
( 40 )] F4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .] U.K.
(41)A measured speed exceeding the value for the maximum design speed by 3 km/h shall be acceptable. An additional 5 % tolerance shall be permitted in order to take into account variations due to tyre size.U.K.
(42)Standard ISO 789-3:1993 (Agricultural tractors — Test procedures — Part 3: Turning and clearance diameters).U.K.
(44)Values in respect of the mechanical strength of the coupling device.U.K.
(45)Not applicable to types of vehicles, systems, components and separate technical units falling under the requirements of Article 37 or Article 53(13) of Regulation (EU) No 167/2013.U.K.
(46)Also applicable to R- or S-category vehicles with a rear coupling device.U.K.
(47)For R- and S-category vehicles indicate the height without optional side/rear panels.U.K.
[F1( 48 ) For R- and S-category vehicles indicate the overhang of the front coupling point.] U.K.
[F1( 49 ) For engines indicate the information relative to the engine type or the engine family type, as applicable without the type-approval extension number.] U.K.
[F1( 52 ) When the tractor is fitted with different optional seats or has a reversible driver’s position (reversible seat and steering wheel), the dimensions in relation to the seat index points (SIP 1, SIP 2, etc.) shall be measured for each case.] U.K.
(53)Steel specifications shall be in accordance with ISO 630:1995 (Structural steels — Plates, wide flats, bars, sections and profiles), Amd 1: 2003.U.K.
(54)Indicate in case that the maximum design speed in the rearward direction of travel is higher than in the forward direction of travel.U.K.
(55)Provide the requested information for: Service braking system; Parking braking system; for vehicles of categories T and C, Secondary braking system; for any additional braking device(s) (and especially retarders) and; for anti-lock braking systems.U.K.
[F4( 56 )] [ F4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .] U.K.
(57)OECD standard code for the official testing of agricultural and forestry tractor performance, OECD Code 2, Edition 2015 of July 2014.U.K.
(59)As defined in point 1.1 of Annex VIII to Commission Delegated Regulation (EU) 2015/208.U.K.
(60)Relevant vehicle electrical/electronic systems or ESAs are those which may emit significant broadband or narrowband radiation and/or those which are involved in the driver's direct control (see point 3.4.2.3 of Part 2 of Annex XV to Commission Delegated Regulation (EU) 2015/208) of the vehicleU.K.
(61)Applicable only for small volume manufacturers as regards section 6 of Annex V to Commission Delegated Regulation (EU) No 1322/2014.U.K.
(62)Alternatively, provide a dimensioned drawing showing the position of the coupling point.U.K.
(63)Machinery, as defined in Article 2(a) of Directive 2006/42/EC of the European Parliament and of the Council.U.K.
(1)

[F1Delete the entry if not applicable.]

(2)

[F1Indicate the alphanumeric code Type-Variant-Version or ‘ TVV ’ allocated to each type, variant and version as set out in point 2.3 of Part B of Annex I to this Regulation. For the identification of variant and versions it may be employed the matrix set out in point 2.2 of Part B of Annex I to this Regulation.]

(3)

[F1Classified according to Article 4 of Regulation (EU) No 167/2013, the coding shall be indicated, e.g. ‘ T4.3a ’ for a low-clearance tractor with a maximum design speed below or equal to 40 km/h.]

Textual Amendments