1.The manufacturer or his representative shall submit to the type-approval authority an application drawn up in accordance with the provisions of this Regulation.
2.An application for EC type-approval following one or more of the procedures of Article 1(2) of this Regulation shall consist of the information folder containing the particulars required by the measures implementing Regulation (EC) No 661/2009 setting out requirements in areas covered by UNECE regulations, and shall be made in accordance with Annex I to Directive 2007/46/EC.
3.The type-approval authority shall confirm that it considers the application to be complete.
4.Any EC or UNECE type-approved components and separate technical units which are installed on a vehicle or incorporated within a second component or separate technical unit need not to be fully described in terms of their particulars in the information document if the type-approval numbers and markings are provided in the information document and the relevant type-approval certificates with annexed information packages are made available to the technical service.
5.Components and separate technical units which have a valid EC type-approval mark shall be accepted even in cases where they are applied instead of components and separate technical units that are required to bear an ECE type-approval mark in the context of measures implementing Regulation (EC) No 661/2009 setting out requirements in areas covered by UNECE regulations.