Regulation (EU) No 748/2012 is amended as follows:
Article 3 is amended as follows:
in paragraph 1, point (a), point (i) is replaced by the following:
its type-certification basis was:
the JAA type-certification basis, for products that have been certificated under JAA procedures, as defined in their JAA data sheet, or
for other products, the type-certification basis as defined in the type-certificate data sheet of the State of design, if that State of design was:
a Member State, unless the Agency determines, taking into account, in particular, certification specifications used and service experience, that such type-certification basis does not provide for a level of safety equivalent to that required by Regulation (EC) No 216/2008 and this Regulation, or
a State with which a Member State had concluded a bilateral airworthiness agreement or similar arrangement under which such products have been certificated on the basis of the certification specifications of that State of design, unless the Agency determines that such certification specifications or service experience or the safety system of that State of design do not provide for a level of safety equivalent to that required by Regulation (EC) No 216/2008 and this Regulation.
The Agency shall make a first evaluation of the implication of the provisions of the second indent in view of producing an opinion to the Commission including possible amendments to this Regulation;’;
in paragraph 2, points (c) and (d) are replaced by the following:
by way of derogation from point 21.A.17A of Annex I (Part 21), the type-certification basis shall be that established by the JAA or, where applicable, the Member State at the date of application for the approval;
compliance findings made under JAA or Member State procedures shall be deemed to have been made by the Agency for the purpose of complying with points 21.A.20(a) and (d) of Annex I (Part 21).’;
Article 5 is deleted;
the following Article 7a is inserted:
1.The holder of an aircraft type-certificate issued before 17 February 2014 intending to deliver a new aircraft to an EU operator on or after 17 February 2014 shall obtain approval in accordance with point 21.A.21(e) of Annex I (Part 21) except for the minimum syllabus of maintenance certifying staff type rating training and except for aircraft validation source data to support the objective qualification of simulator(s). The approval shall be obtained not later than 18 December 2015 or before the aircraft is operated by an EU operator, whichever is the latest. The operational suitability data may be limited to the model which is delivered.
2.The applicant for an aircraft type-certificate for which the application was filed before 17 February 2014 and for which a type-certificate is not issued before 17 February 2014 shall obtain approval in accordance with point 21.A.21(e) of Annex I (Part 21) except for the minimum syllabus of maintenance certifying staff type rating training and for aircraft validation source data to support the objective qualification of simulator(s). The approval shall be obtained not later than 18 December 2015 or before the aircraft is operated by an EU operator, whichever is the latest. Compliance findings made by the authorities in Operational Evaluation Board processes conducted under the responsibility of the JAA or the Agency before the entry into force of this Regulation shall be accepted by the Agency without further verification.
3.Operational Evaluation Board reports and master minimum equipment lists issued in accordance with JAA procedures or by the Agency before the entry into force of this Regulation shall be deemed to constitute the operational suitability data approved in accordance with point 21.A.21(e) of Annex I (Part 21) and shall be included in the relevant type-certificate. Before 18 June 2014 the relevant type-certificate holders shall propose the Agency a division of the operational suitability data in mandatory data and non-mandatory data.
4.Holders of a type-certificate including operational suitability data shall be required to obtain approval of an extension of the scope of their design organisation approval or procedures alternative to design organisation approval, as applicable, to include operational suitability aspects before 18 December 2015.’;
Annex I (Part 21) is amended in accordance with the Annex to this Regulation.