Commission Implementing Regulation (EU) No 396/2013Show full title

Article 1 U.K.

Regulation (EU) No 1014/2010 is amended as follows:

(1)

in Article 3, paragraph 7 is replaced by the following:

‘7. Where a vehicle is equipped with axle tracks of different widths, the Member State shall report the maximum axle width under the parameters “Track width steering axle” or “Track width other axle” in the detailed monitoring data.’;

(2)

Article 5 is replaced by the following:

‘Article 5 Preparation of data by Member States

When completing the detailed monitoring data, Member States shall include:

(a)

for each vehicle with specific emissions of CO₂ of less than 50 g CO₂/km, the number of vehicles registered without applying the multiplication factors laid down in Article 5 of Regulation (EC) No 443/2009;

(b)

for each vehicle designed to be capable of running on ethanol (E85) fuel, the specific emissions of CO₂ without applying the 5 % CO₂ emissions reduction granted to such vehicles in accordance with Article 6 of Regulation (EC) No 443/2009;

(c)

for each vehicle equipped with innovative technologies, the specific emissions of CO₂ without taking into account the CO₂ emissions reduction through innovative technologies granted in accordance with Article 12 of Regulation (EC) No 443/2009.

The detailed monitoring data shall be reported with the precision set out in the table in Annex II to this Regulation.’;

(3)

Article 7 is replaced by the following:

‘Article 7 Vehicles not covered by EC type-approval

1. Where passenger cars are subject to national type-approval of small series in accordance with Article 23 of Directive 2007/46/EC or to individual approval in accordance with Article 24 of that Directive, Member States shall inform the Commission of the respective number of such cars registered in their territory, as specified in the first table in Part C of Annex II to Regulation (EC) No 443/2009.

2. Member States may complete the detailed monitoring data for the vehicles referred to in paragraph 1, and shall in that case use one of the following denominations instead of the name of manufacturer:

(a) “AA-IVA” for reporting vehicle types approved individually;

(b) “AA-NSS” for reporting vehicle types approved nationally in small series.’;

(4)

Annexes I and II to Regulation (EU) No 1014/2010 are replaced by the text set out in the Annex to this Regulation.