http://www.legislation.gov.uk/eur/2012/601/article/48/2012-06-21Commission Regulation (EU) No 601/2012 of 21 June 2012 on the monitoring and reporting of greenhouse gas emissions pursuant to Directive 2003/87/EC of the European Parliament and of the Council (Text with EEA relevance) (repealed)Commission Regulation (EU) No 601/2012 (repealed)Commission Regulation (EU) No 601/2012 of 21 June 2012 on the monitoring and reporting of greenhouse gas emissions pursuant to Directive 2003/87/EC of the European Parliament and of the Council (Text with EEA relevance) (repealed)2020-12-11King's Printer of Acts of Parliamenthttps://webarchive.nationalarchives.gov.uk/eu-exit/https://eur-lex.europa.eu/legal-content/EN/TXT/?uri=CELEX:32012R0601texttext/xmlen2012-06-21 CHAPTER III <Strong>MONITORING OF EMISSIONS OF STATIONARY INSTALLATIONS</Strong> SECTION 4 <Strong> <Emphasis>Special provisions</Emphasis> </Strong> Inherent CO<Inferior>2</Inferior> Article 48 1 Inherent CO2 which is transferred into an installation, including that contained in natural gas or a waste gas including blast furnace gas or coke oven gas, shall be included in the emission factor for that fuel. 2 Where inherent CO2 originates from activities covered by Annex I to Directive 2003/87/EC or included pursuant to Article 24 of that Directive and is subsequently transferred out of the installation as part of a fuel to another installation and activity covered by that Directive, it shall not be counted as emissions of the installation where it originates. However, where inherent CO2 is emitted, or transferred out of the installation to entities not covered by that Directive, it shall be counted as emissions of the installation where it originates. 3 The operators may determine quantities of inherent CO2 transferred out of the installation both at the transferring and at the receiving installation. In that case, the quantities of respectively transferred and received inherent CO2 shall be identical. Where the quantities of transferred and received inherent CO2 are not identical, the arithmetic average of both measured values shall be used in both the transferring and receiving installations’ emission reports, where the deviation between the values can be explained by the uncertainty of the measurement systems. In such case, the emission report shall refer to the alignment of that value. Where the deviation between the values cannot be explained by the approved uncertainty range of the measurement systems, the operators of the transferring and receiving installations shall align the values by applying conservative adjustments approved by the competent authority.