ANNEX I U.K. ADMINISTRATIVE PROVISIONS FOR EC TYPE-APPROVAL

Appendix 5 Model of EC type-approval certificate of an engine type/component as separate technical unit

Addendum to EC type-approval certificate No …

1. ADDITIONAL INFORMATION U.K.

1.1. Particulars to be completed in relation to the type-approval of a vehicle with an engine installed: U.K.

1.1.1.

Make of engine (name of undertaking):

1.1.2.

Type and commercial description (mention any variants):

1.1.3.

Manufacturer's code as marked on the engine:

1.1.4.

Category of vehicle (if applicable) (^b):

1.1.5.

Category of engine: Diesel/Petrol/LPG/NG-H/NG-L/NG-HL/Ethanol (ED95)/Ethanol (E85) (¹)

1.1.6.

Name and address of manufacturer:

1.1.7.

Name and address of manufacturer's authorised representative (if any):

1.2. If the engine referred to in 1.1 has been type approved as a separate technical unit: U.K.

1.2.1.

Type-approval number of the engine/engine family (¹):

1.2.2.

Engine Control Unit (ECU) software calibration number:

1.3. Particulars to be completed in relation to the type-approval of an engine/engine family (¹) as a separate technical unit (conditions to be respected in the installation of the engine on a vehicle): U.K.

1.3.1.

Maximum and/or minimum intake depression:

1.3.2.

Maximum allowable back pressure:

1.3.3.

Exhaust system volume:

1.3.4.

Restrictions of use (if any):

1.4. Emission levels of the engine/parent engine (¹): U.K.

Deterioration Factor (DF): calculated/fixed (¹)

Specify the DF values and the emissions on the WHSC (if applicable) and WHTC tests in the table below

If CNG and LPG fuelled engines are tested on different reference fuels, the tables shall be reproduced for each reference fuel tested.

1.4.1. WHSC test U.K.

Table 4

WHSC test

WHSC test (if applicable)
DFMult/add (1)	CO	THC	NOx	PM Mass	NH3	PM Number
Emissions	CO(mg/kWh)	THC(mg/kWh)	NOx(mg/kWh)	PM Mass(mg/kWh)	NH3ppm	PM Number(#/kWh)
Test result
Calculated with DF
CO2 emissions mass emission: … g/kWh Fuel consumption: … g/kWh

1.4.2. WHTC test U.K.

Table 5

WHTC test

WHTC test
DFMult/add (1)	CO	THC	NOx	PM Mass	NH3	PM Number
Emissions	CO(mg/kWh)	THC(mg/kWh)	NOx(mg/kWh)	PM Mass(mg/kWh)	NH3ppm	PM Number
Cold start
Hot start w/o regeneration
Hot start with regeneration (1)
kr,u (mult/add) (1) kr,d (mult/add) (1)
Weighted test result
Final test result with DF
CO2 emissions mass emission: … g/kWh Fuel consumption: … g/kWh

1.4.3. Idle test U.K.

Table 6

Idle test

Test	CO value(% vol.)	Lambda (1)	Engine speed (min–1)	Engine oil temperature (°C)
Low idle test		N/A
High idle test

1.5 Power measurement U.K.

1.5.1. Engine power measured on test bench U.K.

Table 7

Engine power measured on test bench

Measured engine speed (rpm)
Measured fuel flow (g/h)
Measured torque (Nm)
Measured power (kW)
Barometric pressure (kPa)
Water vapour pressure (kPa)
Intake air temperature (K)
Power correction factor
Corrected power (kW)
Auxiliary power (kW) (1)
Net power (kW)
Net torque (Nm)
Corrected specific fuel consumption (g/kWh)

1.5.2. Additional data U.K.