ANNEX I U.K. ADMINISTRATIVE PROVISIONS FOR EC TYPE-APPROVAL

Appendix 10

Explanatory notes U.K.

(1) Delete where not applicable (there are cases where nothing needs to be deleted when more than one entry is applicable). U.K.

(2) Specify the tolerance. U.K.

(3) Please fill in here the upper and lower values for each variant. U.K.

(4) To be documented in case of a single OBD engine family and if not already documented in the documentation package(s) referred to in line 3.2.12.2.7.0.4. U.K.

(5) Fuel consumption for the combined WHTC including cold and hot part according to Annex VIII. U.K.

(6) To be documented if not documented in the documentation referred to in point 3.2.12.2.7.1.1. U.K.

(7) Delete as appropriate. U.K.

(8) Information concerning engine performance shall only be given for the parent engine. U.K.

(9) Specify the tolerance; to be within ± 3 % of the values declared by the manufacturer. U.K.

(a) If the means of identification of type contains characters not relevant to describe the vehicle, component or separate technical unit types covered by this information document, such characters shall be represented in the documentation by the symbol ‘?’ (e.g. ABC?123??). U.K.

(b) Classified according to definitions listed in Section A of Annex II to Directive 2007/46/EC. U.K.

(l) This figure shall be rounded off to the nearest tenth of a millimetre. U.K.

(m) This value shall be calculated and rounded off to the nearest cm³. U.K.

(n) Determined in accordance with the requirements of Annex XIV. U.K.