Commission Regulation (EU) No 19/2011Show full title

Commission Regulation (EU) No 19/2011 of 11 January 2011 concerning type-approval requirements for the manufacturer’s statutory plate and for the vehicle identification number of motor vehicles and their trailers and implementing Regulation (EC) No 661/2009 of the European Parliament and of the Council concerning type-approval requirements for the general safety of motor vehicles, their trailers and systems, components and separate technical units intended therefor (Text with EEA relevance)

Article 3U.K.Provisions for [F1GB] type-approval of a type of vehicle with regard to the manufacturer’s statutory plate and the vehicle identification number

1.The manufacturer or his representative shall submit to the type-approval authority the application for [F2GB] type-approval of a type of vehicle as regard the lay-out and the location of the manufacturer’s statutory plate and the composition and the location of the vehicle identification number.

2.The application shall be drawn up in accordance with the model information document set out in Part A of Annex III.

3.If deemed necessary by the approval authority or the technical service, the manufacturer shall make available a vehicle representative of the type to be approved for the purposes of inspection.

4.If the relevant requirements set out in Annex I and Annex II to this Regulation are met, the approval authority shall grant a type-approval in accordance with the numbering system set out in [F3Annex IV to Commission Implementing Regulation (EU) 2020/683].

[F4The approval authority] may not assign the same number to another vehicle type.

5.For the purpose of paragraph 4, the type-approval authority shall deliver [F5a GB] type-approval certificate established in accordance with the model set out in Part B of Annex III.

Textual Amendments