xmlns:atom="http://www.w3.org/2005/Atom" xmlns:atom="http://www.w3.org/2005/Atom"
Article 2.The Commission shall inform the Executive Secretary of the Economic...
Article 3.This Regulation shall enter into force on the day following...
2. An approval certificate conforming to the standard form of Annex...
3. The approval certificate shall be kept on the road vehicle....
4. Road vehicles shall be produced every two years, for the...
5. If a road vehicle no longer complies with the technical...
6. If the essential characteristics of a road vehicle are changed,...
7. The competent authorities of the country of registration of the...
Procedure for approval by design type (series of road vehicles)...
9. Where road vehicles are manufactured by type series, the manufacturer...
10. The manufacturer shall state in his application the identification numbers...
11. The application shall be accompanied by drawings and a detailed...
12. The manufacturer shall give an undertaking in writing that he...
13. The competent authority shall state what changes, if any, must...
14. No approval by design-type shall be granted unless the competent...
15. The competent authority shall notify the manufacturer in writing of...
16. The competent authority shall take the necessary steps to issue...
17. The holder of the approval certificate shall, before using the...
18. When a vehicle which has been approved by design-type is...
ANNEX REGARDING APPROVAL OF CONTAINERS
Provisions common to both approval procedures
2. The competent authority responsible for granting approval shall issue to...
3. The beneficiary of approval shall affix an approval plate to...
4. The approval plate shall be affixed permanently and in a...
5. The approval plate, conforming to Model I reproduced in Appendix...
6. If a container no longer complies with the technical conditions...
7. If the essential characteristics of a container are changed, the...
Special provisions for approval by design type at the manufacturing...
8. Where the containers are manufactured by type series, the manufacturer...
9. The manufacturer shall state in his application the identification numbers...
10. The application shall be accompanied by drawings and a detailed...
11. The manufacturer shall give an undertaking in writing that he...
12. The competent authority shall state what changes, if any, must...
13. No type-approval by design type shall be granted unless the...
14. When a container type is approved there shall be issued...
Special provisions for approval at a stage subsequent to manufacture...