contain one of the text warnings listed in Annex I and a corresponding colour photograph specified in the picture library in Annex II;

include smoking cessation information such as telephone numbers, e-mail addresses or Internet sites intending to inform consumers about the programmes that are available to support persons who want to stop smoking;

cover 65 % of both the external front and back surface of the unit packet and any outside packaging. Cylindrical packets shall display two combined health warnings, equidistant from each other, each covering 65 % of their respective half of the curved surface;

show the same text warning and corresponding colour photograph on both sides of the unit packets and any outside packaging;

appear at the top edge of a unit packet and any outside packaging, and be positioned in the same direction as any other information appearing on that surface of the packaging. Transitional exemptions from that obligation on the position of the combined health warning may apply in Member States where tax stamps or national identification marks used for fiscal purposes remain mandatory, as follows:

1. (i)

   in those cases, where the tax stamp or national identification mark used for fiscal purposes is affixed at the top edge of a unit packet made of carton material, the combined health warning that is to appear on the back surface may be positioned directly below the tax stamp or national identification mark;

2. (ii)

   where a unit packet is made of soft material, Member States may allow for a rectangular area to be reserved for the tax stamp or national identification mark used for fiscal purposes of a height not exceeding 13 mm between the top edge of the packet and the top end of the combined health warnings.

The exemptions referred to in points (i) and (ii) shall apply for a period of three years from 20 May 2016. Brand names or logos shall not be positioned above the health warnings;

be reproduced in accordance with the format, layout, design and proportions specified by the Commission pursuant to paragraph 4;

in the case of unit packets of cigarettes, respect the following dimensions:

1. (i)

   height: not less than 44 mm;

2. (ii)

   width: not less than 52 mm.

adapt the text warnings listed in Annex I taking into account scientific and market developments;

establish and adapt the picture library referred to in point (a) of paragraph 1 of this Article taking into account scientific and market developments.