Article 3
Directive 70/156/EEC is amended as follows:
1. Annex I is amended as follows:
  1. the following line is added to point 0.5:
Name and address of authorised representative, if any:
  2. the following point is inserted:
12.7.

Table of installation and use of RF transmitters in the vehicle(s), if applicable (see Annex I, 3.1.8.):
frequency bands (Hz) | max. output power (W) | antenna position at vehicle, specific conditions for installation and/or use
The applicant for type-approval must also supply, where appropriate:
    - Appendix 1
A list (with make(s) and type(s) of all electrical and/or electronic components concerned by this Directive (see points 2.1.9 and 2.1.10) and not previously listed.
    - Appendix 2
Schematics or drawing of the general arrangement of electrical and/or electronic components (concerned by this Directive) and the general wiring harness arrangement.
    - Appendix 3
Description of vehicle chosen to represent the type
      - Body style:
      - Left or right hand drive:
      - Wheelbase:
    - Appendix 4
Relevant test report(s) supplied by the manufacturer or approved/recognised laboratories for the purpose of drawing up the type-approval certificate.
2. In Annex III, Section A, the following line is added to point 0.5:
Name and address of authorised representative, if any:
.