Article 3U.K.

Directive 70/156/EEC is amended as follows:

1.

Annex I is amended as follows:

(a)

the following line is added to point 0.5:

‘Name and address of authorised representative, if any:’

(b)

the following point is inserted:

‘12.7.Table of installation and use of RF transmitters in the vehicle(s), if applicable (see Annex I, 3.1.8.):

frequency bands (Hz)max. output power (W)antenna position at vehicle, specific conditions for installation and/or use

The applicant for type-approval must also supply, where appropriate:

  • Appendix 1

    A list (with make(s) and type(s) of all electrical and/or electronic components concerned by this Directive (see points 2.1.9 and 2.1.10) and not previously listed.

  • Appendix 2

    Schematics or drawing of the general arrangement of electrical and/or electronic components (concerned by this Directive) and the general wiring harness arrangement.

  • Appendix 3

    Description of vehicle chosen to represent the type

    • Body style:

    • Left or right hand drive:

    • Wheelbase:

  • Appendix 4

    Relevant test report(s) supplied by the manufacturer or approved/recognised laboratories for the purpose of drawing up the type-approval certificate.’

2.

In Annex III, Section A, the following line is added to point 0.5:

‘Name and address of authorised representative, if any:’.