Chwilio Deddfwriaeth

Teitl: (neu eiriau allweddol yn y teitl)

Blwyddyn:

Rhif:

Math:

Chwiliad Uwch

EEC (repealed)Dangos y teitl llawn

Council Directive 93/14/EEC of 5 April 1993 on the braking of two or three-wheel motor vehicles (repealed)

Pa Fersiwn

Y Diweddaraf sydd Ar Gael (Diwygiedig)
Gwreiddiol (Fel y’i mabwysiadwyd gan yr UE)

Dewisiadau Agor

Rhagor o Adnoddau

Fersiwn Cyfnodolyn Swyddogol yr UE

PDF o Fersiynau Diwygiedig

ddiwygiedig 28/03/20060.17 MB

Mae hon yn Gyfarwyddeb sy’n deillio o’r UE

Mae hon yn eitem o ddeddfwriaeth sy’n deillio o’r UE

Mae unrhyw newidiadau sydd wedi cael eu gwneud yn barod gan y tîm yn ymddangos yn y cynnwys a chyfeirir atynt gydag anodiadau.Ar ôl y diwrnod ymadael bydd tair fersiwn o’r ddeddfwriaeth yma i’w gwirio at ddibenion gwahanol. Y fersiwn legislation.gov.uk yw’r fersiwn sy’n weithredol yn y Deyrnas Unedig. Y Fersiwn UE sydd ar EUR-lex ar hyn o bryd yw’r fersiwn sy’n weithredol yn yr UE h.y. efallai y bydd arnoch angen y fersiwn hon os byddwch yn gweithredu busnes yn yr UE.

Y fersiwn yn yr archif ar y we yw’r fersiwn swyddogol o’r ddeddfwriaeth fel yr oedd ar y diwrnod ymadael cyn cael ei chyhoeddi ar legislation.gov.uk ac unrhyw newidiadau ac effeithiau a weithredwyd yn y Deyrnas Unedig wedyn. Mae’r archif ar y we hefyd yn cynnwys cyfraith achos a ffurfiau mewn ieithoedd eraill o EUR-Lex.

Status:

Dyma’r fersiwn wreiddiol (fel y’i gwnaed yn wreiddiol).

1.1.General

1.1.1.The performance prescribed for braking devices is based on the stopping distance. The performance of a braking device is determined either by measuring the stopping distance in relation to the initial speed or by the response time of the device and the mean fully-developed deceleration.

1.1.2.The stopping distance is the distance covered by the vehicle from the moment when the driver begins to actuate the control of the device until the moment when the vehicle stops. The initial speed is the speed at the moment when the driver begins to actuate the control of the device. In the formula given below, for measurement of braking performance:

initial speed in kilometres per hour, and

stopping distance, in metres.

1.1.3.For component type-approval, the braking performance must be measured during road tests conducted under the following conditions:

1.1.3.1.the vehicle's condition as regards its mass must be as prescribed for each type of test and must be specified in the test report;

1.1.3.2.the test must be carried out at the speed and in the manner prescribed for each type of test: if the maximum speed of the vehicle does not conform to the speed prescribed, the test must be carried out under the special alternative conditions provided;

1.1.3.3.the prescribed performance must be obtained without locking of the wheel(s), without deviation of the vehicle from its course, and without any abnormal vibration;

1.1.3.4.during the tests the force applied to the brake control in order to obtain the prescribed performance must not exceed the maximum laid down for the test vehicle's category.

1.1.4.Test conditions

1.1.4.1.The service braking tests must be carried out under the following conditions:

1.1.4.1.1.at the start of the test or any series of tests the tyres must be cold and at the pressure prescribed for the load actually borne by the wheels when the vehicle is stationary;

1.1.4.1.2.the vehicle must be loaded, when required to be tested in the laden condition, with the load distributed in accordance with the manufacturer's prescription;

1.1.4.1.3.for all the type-0 tests the brakes must be cold: a brake is deemed to be cold when the temperature measured on the disc or on the outside of the drum is less than 100 °C;

1.1.4.1.4.the driver must shall be seated on the saddle as for normal driving and must maintain the same position throughout the test;

1.1.4.1.5.the test area must be level, dry and have a surface affording good adhesion;

1.1.4.1.6.the test must be performed when there is no wind liable to affect the test result.

Yn ôl i’r brig

Options/Help

Print Options

PrintThe Whole Directive
- PDF The Whole Directive
- Tudalen we The Whole Directive
PrintThe Whole Annex
- PDF The Whole Annex
- Tudalen we The Whole Annex
PrintThe Whole Division
- PDF The Whole Division
- Tudalen we The Whole Division
PrintThis Division only
- PDF This Division only
- Tudalen we This Division only

Mae deddfwriaeth ar gael mewn fersiynau gwahanol:

Y Diweddaraf sydd Ar Gael (diwygiedig):Y fersiwn ddiweddaraf sydd ar gael o’r ddeddfwriaeth yn cynnwys newidiadau a wnaed gan ddeddfwriaeth ddilynol ac wedi eu gweithredu gan ein tîm golygyddol. Gellir gweld y newidiadau nad ydym wedi eu gweithredu i’r testun eto yn yr ardal ‘Newidiadau i Ddeddfwriaeth’.

Gwreiddiol (Fel y’i mabwysiadwyd gan yr UE): Mae'r wreiddiol version of the legislation as it stood when it was first adopted in the EU. No changes have been applied to the text.

Dewisiadau Agor

Dewisiadau gwahanol i agor deddfwriaeth er mwyn gweld rhagor o gynnwys ar y sgrin ar yr un pryd

Rhagor o Adnoddau

Gallwch wneud defnydd o ddogfennau atodol hanfodol a gwybodaeth ar gyfer yr eitem ddeddfwriaeth o’r tab hwn. Yn ddibynnol ar yr eitem ddeddfwriaeth sydd i’w gweld, gallai hyn gynnwys:

y PDF print gwreiddiol y fel adopted version that was used for the EU Official Journal
rhestr o newidiadau a wnaed gan a/neu yn effeithio ar yr eitem hon o ddeddfwriaeth
pob fformat o’r holl ddogfennau cysylltiedig
slipiau cywiro
dolenni i ddeddfwriaeth gysylltiedig ac adnoddau gwybodaeth eraill

Rhagor o Adnoddau

Defnyddiwch y ddewislen hon i agor dogfennau hanfodol sy’n cyd-fynd â’r ddeddfwriaeth a gwybodaeth am yr eitem hon o ddeddfwriaeth. Gan ddibynnu ar yr eitem o ddeddfwriaeth sy’n cael ei gweld gall hyn gynnwys:

y PDF print gwreiddiol y fel adopted fersiwn a ddefnyddiwyd am y copi print
slipiau cywiro

liciwch ‘Gweld Mwy’ neu ddewis ‘Rhagor o Adnoddau’ am wybodaeth ychwanegol gan gynnwys

rhestr o newidiadau a wnaed gan a/neu yn effeithio ar yr eitem hon o ddeddfwriaeth
manylion rhoi grym a newid cyffredinol
pob fformat o’r holl ddogfennau cysylltiedig
dolenni i ddeddfwriaeth gysylltiedig ac adnoddau gwybodaeth eraill

legislation.gov.uk

Chwilio Deddfwriaeth

Council Directive 93/14/EEC (repealed)Dangos y teitl llawn

You are here:

Pa Fersiwn

Dewisiadau Agor

Rhagor o Adnoddau

PDF o Fersiynau Diwygiedig

Mae hon yn Gyfarwyddeb sy’n deillio o’r UE

Mae hon yn eitem o ddeddfwriaeth sy’n deillio o’r UE

Status:

1.1.General

1.1.1.The performance prescribed for braking devices is based on the stopping distance. The performance of a braking device is determined either by measuring the stopping distance in relation to the initial speed or by the response time of the device and the mean fully-developed deceleration.

1.1.3.For component type-approval, the braking performance must be measured during road tests conducted under the following conditions:

1.1.3.1.the vehicle's condition as regards its mass must be as prescribed for each type of test and must be specified in the test report;

1.1.3.2.the test must be carried out at the speed and in the manner prescribed for each type of test: if the maximum speed of the vehicle does not conform to the speed prescribed, the test must be carried out under the special alternative conditions provided;

1.1.3.3.the prescribed performance must be obtained without locking of the wheel(s), without deviation of the vehicle from its course, and without any abnormal vibration;

1.1.3.4.during the tests the force applied to the brake control in order to obtain the prescribed performance must not exceed the maximum laid down for the test vehicle's category.

1.1.4.Test conditions

1.1.4.1.The service braking tests must be carried out under the following conditions:

1.1.4.1.1.at the start of the test or any series of tests the tyres must be cold and at the pressure prescribed for the load actually borne by the wheels when the vehicle is stationary;

1.1.4.1.2.the vehicle must be loaded, when required to be tested in the laden condition, with the load distributed in accordance with the manufacturer's prescription;

1.1.4.1.3.for all the type-0 tests the brakes must be cold: a brake is deemed to be cold when the temperature measured on the disc or on the outside of the drum is less than 100 °C;

1.1.4.1.4.the driver must shall be seated on the saddle as for normal driving and must maintain the same position throughout the test;

1.1.4.1.5.the test area must be level, dry and have a surface affording good adhesion;

1.1.4.1.6.the test must be performed when there is no wind liable to affect the test result.

Options/Help

Print Options

PrintThe Whole Directive

PrintThe Whole Annex

PrintThe Whole Division

PrintThis Division only

Mae deddfwriaeth ar gael mewn fersiynau gwahanol:

Dewisiadau Agor

Rhagor o Adnoddau

Rhagor o Adnoddau