Commission Delegated Regulation (EU) 2015/96 (repealed)Show full title

2. Exhaust System (Silencer)

2.1. If the agricultural and forestry vehicle is fitted with a device designed to reduce the exhaust noise (silencer), the requirements of this section shall apply. If the inlet of the engine is fitted with an air filter which is necessary in order to ensure compliance with the permissible sound level, the filter shall be considered to be part of the silencer, and the requirements of this point 2 shall also apply to that filter.

The exhaust tailpipe must be positioned in such a way that the exhaust gases cannot penetrate inside the cab.

Figure 2

Measuring positions for stationary agricultural and forestry vehicles

2.2. A drawing of the exhaust system must be annexed to the agricultural and forestry vehicle type-approval certificate.

2.3. The silencer must be marked with a reference to its make and type which is clearly legible and indelible.

2.4. The use of fibrous absorbent material is permitted in the construction of silencers only if the following conditions are fulfilled:

2.4.1.

the fibrous absorbent material may not be placed in those parts of the silencer through which gases pass;

2.4.2.

suitable devices must ensure that the fibrous absorbent material is kept in place for the whole time that the silencer is being used;

2.4.3.

the fibrous absorbent material must be resistant to a temperature at least 20 % higher than the operating temperature (degrees C) which may occur in the region of the silencer where those fibrous absorbent materials are situated.