Search Legislation

Commission Directive 2006/119/ECShow full title

Commission Directive 2006/119/EC of 27 November 2006 amending for the purposes of adapting to technical progress Directive 2001/56/EC of the European Parliament and of the Council concerning heating systems for motor vehicles and their trailers (Text with EEA relevance)

 Help about what version

What Version

Close

This is a legislation item that originated from the EU

After exit day there will be three versions of this legislation to consult for different purposes. The legislation.gov.uk version is the version that applies in the UK. The EU Version currently on EUR-lex is the version that currently applies in the EU i.e you may need this if you operate a business in the EU.

The web archive version is the official version of this legislation item as it stood on exit day before being published to legislation.gov.uk and any subsequent UK changes and effects applied. The web archive also captured associated case law and other language formats from EUR-Lex.

Status:

This is the original version (as it was originally adopted).

ANNEX

Directive 2001/56/EC is amended as follows:

1.

The following line is added at the end of the ‘list of Annexes’:

  1. Annex IX.Additional provisions applicable to certain vehicles as defined in Directive 94/55/EC

2.

Annex VIII is amended as follows:

(a)

The title of section 1 is replaced by the following:

1.LPG HEATING SYSTEMS FOR ROAD USE IN MOTOR VEHICLES

(b)

Point 1.1.6.2 is replaced by the following:

1.1.6.2.no uncontrolled release due to an accidental disconnection can occur. Means shall be provided to stop the flow of LPG by installing a device directly after, or in, a cylinder or container mounted regulator, or, if the regulator is mounted remote from the cylinder or container, a device shall be installed directly before the hose or pipe from the cylinder or container and an additional device shall be installed in, or after, the regulator.

(c)

The title of Section 2 is replaced by the following:

2.LPG HEATING SYSTEMS FOR STATIONARY USE ONLY IN MOTOR VEHICLES AND THEIR TRAILERS

3.

The following Annex IX is added:

‘ANNEX IXADDITIONAL PROVISIONS APPLICABLE TO CERTAIN VEHICLES AS DEFINED IN DIRECTIVE 94/55/EC(1)

1.SCOPE

This annex applies to vehicles to which specific requirements concerning combustion heaters and their installation laid down in Directive 94/55/EC apply.

2.DEFINITIONS

For the purpose of this Annex, the definitions of the vehicle designations EX/II, EX/III, AT, FL and OX set out in Chapter 9.1 of Annex B to Directive 94/55/EC apply.

3.TECHNICAL PROVISIONS

3.1.General (EX/II, EX/III, AT, FL and OX vehicles)
3.1.1.The combustion heaters and their exhaust gas routing shall be designed, located, protected or covered so as to prevent any unacceptable risk of heating or ignition of the load. This requirement shall be considered as fulfilled if the fuel tank and the exhaust system of the appliance conform to the provisions set out in the points 3.1.1.1 and 3.1.1.2. Compliance with those provisions shall be verified on the completed vehicle.
3.1.1.1.Any fuel tanks for supplying the appliance shall meet the following requirements:
(a)

in the event of any leakage, the fuel shall drain to the ground without coming into contact with hot parts of the vehicle or the load;

(b)

fuel tanks containing petrol shall be equipped with an effective flame trap at the filler opening or with a closure enabling the opening to be kept hermetically sealed.

3.1.1.2.The exhaust system as well as the exhaust pipes shall be so directed or protected to avoid any danger to the load through heating or ignition. Parts of the exhaust system situated directly below the fuel tank (diesel) shall have a clearance of at least 100 mm or be protected by a thermal shield.
3.1.2.The combustion heater shall be switched on manually. Programming devices shall be prohibited.
3.2.EX/II and EX/III vehicles

Combustion heaters using gaseous fuels are not permitted.

3.3.FL vehicles
3.3.1.The combustion heaters shall be put out of operation by at least the following methods:
(a)

intentional manual switching off from the driver’s cab;

(b)

stopping of the vehicle engine; in this case the heating device may be restarted manually by the driver;

(c)

start-up of a feed pump on the motor vehicle for the dangerous goods carried.

3.3.2.After running is permitted after the combustion heaters have been put out of operation. For the methods set out in points (b) and (c) of paragraph 3.3.1 the supply of combustion air shall be interrupted by suitable measures after an after-running cycle of not more than 40 seconds. Only heaters for which proof has been furnished that the heat exchanger is resistant to the reduced after-running cycle of 40 seconds for the time of their normal use shall be used.

Back to top

Options/Help

Print Options

Close

Legislation is available in different versions:

Latest Available (revised):The latest available updated version of the legislation incorporating changes made by subsequent legislation and applied by our editorial team. Changes we have not yet applied to the text, can be found in the ‘Changes to Legislation’ area.

Original (As adopted by EU): The original version of the legislation as it stood when it was first adopted in the EU. No changes have been applied to the text.

Close

Opening Options

Different options to open legislation in order to view more content on screen at once

Close

More Resources

Access essential accompanying documents and information for this legislation item from this tab. Dependent on the legislation item being viewed this may include:

  • the original print PDF of the as adopted version that was used for the EU Official Journal
  • lists of changes made by and/or affecting this legislation item
  • all formats of all associated documents
  • correction slips
  • links to related legislation and further information resources
Close

More Resources

Use this menu to access essential accompanying documents and information for this legislation item. Dependent on the legislation item being viewed this may include:

  • the original print PDF of the as adopted version that was used for the print copy
  • correction slips

Click 'View More' or select 'More Resources' tab for additional information including:

  • lists of changes made by and/or affecting this legislation item
  • confers power and blanket amendment details
  • all formats of all associated documents
  • links to related legislation and further information resources