7. Schedule 3 shall be amended by—
(a)the substitution of the words “, 1.5 or 1.6” for the words “ or 1.5” to the heading above paragraph 4;
(b)the addition after paragraph 15 of the following paragraphs—
“Subsidiary Hazard Labelling
(16) The label required by regulation 6(5) shall—
(a)be a square set with its sides at an angle 45° to the vertical;
(b)be in the form of the following diagram; and
(c)comply with the measurements in the diagram except that—
(i)larger measurements may be used in which case the measurements shall be increased proportionally, or
(ii)where, in order to comply with regulation 10(1), a smaller label is necessary, the dimensions may be decreased proportionally whilst remaining as large as is reasonably practicable for the purpose of such compliance.
(17) The label required by Regulation 6(6) shall—
(a)be a square set with its sides at an angle 45° to the vertical;
(b)be in the form of the following diagram; and
(c)comply with the measurements in the diagram except that—
(i)larger measurements may be used in which case the measurements shall be increased proportionally, or
(ii)where, in order to comply with regulation 10(1), a smaller label is necessary, the dimensions may be decreased proportionally whilst remaining as large as is reasonably practicable for the purpose of such compliance.”.